Product number: HFN4
The apparatus consists of a rotating circular turntable attached onto the end of a vertical shaft. The shaft is held vertical within a sturdy wall bracket that must be attached to a rigid vertical surface, i.e. a wall.

At the lower tip of the shaft a special fixing has been created to accept a variety of end pivots. Mating seating's have been manufactured for the end pivots. The seating's positively locate at the bottom of the wall bracket so that they mate with their respective seating's but do not rotate under testing.

The seating's are made from different materials and with different internal cone angles.

Pure torsion is applied to the table through a pair of diametrically opposite loaded cords and pulleys. A set of calibrated weights and the hangers are supplied.

To vary the thrust on the end pivot, the calibrated weights are added incrementally to the turntable surface. Weights are then added to the Load hangers to calculate the necessary parameters.

A comprehensive Instruction manual and 2 year warranty are also supplied. A set of optionally available seating's and end pivots are also available.

Specifications and resources

Four pivot sets at angles of 60°, 90°, 120°, 180° (flat)
Turntable mass: Approximately 1kg
Turntable effective diameter: Ø200mm
Thrust bearing seating supplied